View Single Post
Old 8th April 2013
  #44
Gear Head
 
Studio ManCave's Avatar
 

Hey, I´m back at the studio.

My schematics are actually different from the ones on the net in that they are not showing the +-10V rails in connector P6... Everything else is the same.

I also measured the pins 27 and 28 of P6 and there was nothing.

My schematics also do show the 10V rails going to the VOL and BALANCE pots so it seems I am missing the 10V rails which is why I´m not getting the signal.

Here´s a picture of the pinouts in my paper schematics. Looks like we´re getting somewhere.
Attached Thumbnails
Studer 903 problems-wp_000851.jpg