View Single Post
Old 20th May 2006
  #2
Gear Maniac
 
davenutz's Avatar
 

how are your inputs and outputs assigned?


In the "AUX" channel strip, the input should be a buss, either stereo or mono, and the output should be your stereo outputs (or the buss #s corresponding to a stem/submix.)

you send to the aux input using the buss you assigned as its inputs, so in the PT mix window, in the audio channels you wish to send to the reverb, create a new send from the dropdown points (top 5 are inserts, bottom 5 or 10 are sends)

remember to raise the level of the return and sends, otherwise you wont hear anything.


ALSO, remeber to place the D-verb on an insert point on the aux.