View Single Post
Old 28th May 2003
  #2
The Distressor's "daddy"
 
Dave Derr's Avatar
 

Hmmm - I've never heard this comment before.

The front end of the Distressor is active and fully balanced. Its capable of recieving +26dBm differentially, which should handle just about anything. The one danger you can have these days, which is mentioned in the manual a couple times, is if you are coming from an unterminated transformer device, into the transformerless front end of the Distressor. As in most active devices, the front end can recieve low or medium impedance signals, so one should probably make sure there is a 600 - 1K ohm resistor across a transformer device going into the Distressor. Also, sometimes its just a matter of decreasing the transformer output a little to get below the unterminated transforrmer saturation point.

The fact that you mention guitars makes me think you could have the attack time, or release time too fast, or need to engage the Det HP. Heavy guitars are already super compressed thru clipping, with little dynamic range, BUT... they have a huge amount of low "modulation" frequencies in them. These frequencies could cause nasty crackling on any compressor whose attack is faster than a millisecond... and the Distressor attacks in Microseconds. Try moving the attack up to 3 or 4(or more), the release slightly longer, OR, sometimes a simple click of the Det HP will get rid of any modulation distortion, as stated in the manual.

All the clipping in the Distressor happens after the compressor circuit, as shown in the block diagram in the manual. The front end should have a huge dynamic range, and really never clip, which helps accounts for people liking them on drums and transients, where you can slam 30 dB of gain reduction into them without crapping out.

As always, we'd be glad to look at your Distressor for free, if you think there is a problem!