View Single Post
Old 21st October 2009
  #23
Gear Nut
 

After wrestling with the thing down a flight of stairs it's finally upright in the control room.

I've been fighting with it and the manual to get audio/mic signal to pass through it. and I finally was successful tonight.

It's almost like whenever you get a new piece of gear you have to learn to speak it's "language" and if you can't you're screwed. Anyhow started to get my head around their patching system/terminology so we're off to a good start.

Now that I have this console I need a source for Molex & Mini-TT Connectors for patching. Do you have any suggestions? I can DIY the cables if that will be cheaper.

here are some rough shots of the board.
Attached Thumbnails
Auditronics 710 console?-img_8287.jpg   Auditronics 710 console?-img_8288.jpg