View Single Post
Old 24th September 2009
  #27
Lives for gear
 

Just do what the analog mixers do, tape and a marker. If you are using bank switching on the digital controller then write each bank down on the tape over each other. Simple and cheap to use what you have. Anyone making a custom desk (like for the Behringers) then at least design in a dry erase scribble strip into it. While it's nice to have an electronic scribble strip, you have to give up width to keep the faders close together which results with too few characters on the strip to help much. It's just choosing your poisen, wide strips kills being able to move lots of faders at the same time (fingers only stretch so much).