View Single Post
Old 28th July 2005
  #2
Gear Head
 

Midas connections

Hi,
I will give this a shot - ( Im not that sharp ! ) , anyway the block diagram of the venice
I believe shows the line ins are balanced , and the direct outs are not . I just went thru
this with connections from protools . At first I had a snake with xlr connections .
(already had it ) . and found it to be to hot going in to the midas . I posted here and
an informative member let me know to use the line ins . It worked great - I have more (flexable) head room to mess with on the board . I had a db25 cable with no ends on it and just soldered on some TRS connectors on the end , it works fine .
Anyway this is what I have found out so far , If this is wrong hopefully someone else
will chime in and help out .
Mike