View Single Post
Old 28th July 2005
  #7
Here for the gear
 
Rakmount's Avatar
 

Thanks for the responses.

The major point is that you cannot lift the ground on a mic input. That much I now know.

So what have I done in the interim?

Got an XLR Patch Bay (16 points -- ins/outs). So now, it's like this:

Mic Tie Line @ Patch Bay (XLR)
-->Mic Pre Input (XLR)
-->Mic Pre Output (Bantam)
-->Protools Input (Bantam)

Everything is A-Ok with that. Unfortunately, it does mess up my neat configuration and labelling with some other floating XLR cables that I had located on the Bantam patch bay.

Again, thanks for the help.