View Single Post
Old 23rd December 2002
  #7
Lives for gear
 
Midlandmorgan's Avatar
 

I did a quasi DIY...took an old Bassman cab and tweaked it a bit...1st thing was to split the two speakers so the cab could be run as 2x12 4 ohm or 2 1-12 8 ohm each side...then put a replacement back that can be taken off by removing 8 screws instead of the 25 or so Fender put on....

To change out speakers, you may need to cut off every other speaker retainer bolt, to accomodate Celestions and other 4 bolt basket designs....madd