View Single Post
Old 16th December 2007
  #11
Gear Addict
 
yoink's Avatar
 

I've used the Grabit too (once) for rack gear. I had to re-wire an XLR output and stripped two screws because they were in too tightly. The bit worked perfectly. Pulled the screws out without damaging the gear.

Be sure to have a vacuum handy to suck up the fillings though, you don't want those little nasties getting through any ventilation holes in the equipment.

And breathe a little. I don't know about you folks, but I freaked at first when I first stripped the screws on a prized piece of equipment. I often make the most mistakes when I panic and subsequently rush/force things.