View Single Post
Old 26th June 2020
  #1
Lives for gear
 

Is there a minimum effective width for BAD panels? And when do I need the inverse?

Would like to retrofit some absorption panels in my live room with BAD diffusors. Panels are 2" thick 703, 24" wide 96" tall (61cm x 244cm). Wasn't sure if 24" wide is too narrow, and not sure how many inverses or different patterns I need. There will be a total of 9 panels that I'm retrofitting in a room that's 26' long, 18' wide, 12' ceilings (8m,5.5m,3.6m). The panels will be hanging on the long walls - some of them directly across from each other, some of them staggered.

I've found some templates in this forum, but most of them look 48"x48", mirrored down the center. I wasn't sure if I could chop that template down the middle and stack it to create a template 24"x96". there will be a total of 9 panels that I'm retrofitting in a room that's 26' long, 18' wide, 12' ceilings. The panels will be hanging on the long walls - some of them directly across from each other, some of them staggered.

Planning on 12mm holes based on my research.