View Single Post
Old 13th February 2020
  #2
Lives for gear
 

Well,

I would say, it must be annoying to be swapping cables going to your speakers from your loop station to your interface and back as you change what you are doing. So I would consider routing it in a way where you can use them all at the same time. If you dont have the inputs avaiable on your interface, you could consider a small 4 input 2 output mixer.

Feed your interface into two channels and loop station into the other 2.

That being said, assuming you are actually using the correct outputs on the loop station, it would seem as though there might be a problem with the loop station outputs. Since you seem to have done all the correct troubleshooting (Try speakers with another source, use a different output with your loop station (Headphones))

So either the loop station output is broken, you are using the wrong outputs or there is some sort of output volume control that is simple too loud for the input of the speakers.

Unless you have some other variables that you didn't mention? Are you using the same cables from your loop station to your speakers as you are when you go interface to speakers?