View Single Post
Old 16th January 2020
  #5
Lives for gear
 
crosscutred's Avatar
 

Quote:
Originally Posted by Jay Rose View Post
MCI remote buttons are usually floating high when off, pulled down to -15v when pressed. So paralleling them isn't a problem, and static isn't likely to be an issue.
Thank you.
This is the transport buttons isn't it?
I think they are already parallelled on the machine and remote aren't they?
Another set shouldn't be an issue.
I have a cable for a sync unit which I can use to tap into the remote loom.

It's the "loc" button that works by completing a 5v circuit. Do you think that will survive a 50' cable run? (Live room to machine to remote)
I've had a look at the schematic and it would be an easy job to fit a relay.