View Single Post
Old 7th January 2020
  #6
Gear Guru
 
tINY's Avatar

install a single, 10w (or greater) 8ohm resistor across the 1/4" jack. Then, use the jack to connect to your input.

The resistor and the input of your pre-amp are in parallel. This is a single ended solution. If you need a balanced feed (XLR or TRS) then you'll need a passive DI box as well.

Or, you could buy this: https://www.radialeng.com/product/headload


See also -

https://www.premierguitar.com/articl...ors-and-reamps

https://carvinaudio.com/blogs/guitar...-can-and-can-t




-tINY