View Single Post
Old 19th December 2019
  #3
Gear Head
 
Thisiscobras's Avatar
 

Quote:
Originally Posted by mrfantastic View Post
Depends what the pins that you shroted out were connected to. Some chips have pins that aren't used at all and if the supply voltage pin wasn't involved it may be ok. Power it up and see what happens. If you've already damaged it you're not risking it any further and if the short was momentary you might have got away with it although the danger is that the damage could be so microscopic that it works ok for a while but dies in future - no way of knowing until it dies unfortunately unless you have an electron microscope.
Thanks much for your reply. Here's the other half of the story. I'm pretty scared at this point:

I've been trying to fix what was a very small issue on my beloved SCI Prophet 600 for the past month. Simply 1 Oscillator was out of tune. Everything else worked flawlessly. I was methodically replacing parts and testing after each. All was well as I was slowly tracking down the exact problem. That was until last night when I got the bright idea to use my multimeter to try and check/compare IC chip voltages between a good voice and the one I was having a problem with. I checked the direct voice IC chips 4016 (quad analog) and 4053 (multiplexer) for 2 voices as well as 2 small op amp chips in the S/H section. I grounded the negative probe on the metal chassis and used the positive to check the legs of the ICs. Apparently I'm an idiot for doing this and/or I accidentally caught 2 legs at once and hopefully just shorted a chip only. All was well minus the 1 Oscillator prior to this and now when I power on immediately I hear a loud screeching/white noise followed by what sounds like an Orbital CD played backwards and not in a good way. Keys respond as does the membrane panel and display. No matter what I do there is just noise in the background and all sorts of digital vomit. I'm really hoping I simply just fried one of the chips I tested and that's it. I'm in the process of putting together an order to replace the 6 total chips I touched. I'm really hoping just to get a little peace of mind in the meantime that this is likely all I did and that whatever happened didn't spread down the line to other places.