View Single Post
Old 8th August 2019
  #7
Gear Head
 

Quote:
Originally Posted by JPogo View Post
Search on ebay (or probably other places as well). Just searched for "DX7 display" and it came right up; try likewise with whatever model you have in mind



I similarly replaced my DX21 display a couple years ago, with a backlit one purchased from ebay. It did not require soldering, and came with step-by-step directions.

That being said, I would not call it an easy change: the new display re-uses the same glass front-piece, which the old display is glued to.

The instructions simply tell you to separate the glass and the display with a knife or razor, and this is indeed what you must do. What they do not say is that this will be very difficult.

1. The glue is very strong, so you must use force -- but if you slip, you may very well be jabbing said knife/blade/etc into your own hand. Be very careful.

2. The glass display is partially blacked out, around the edge, leaving the display part clear. Any slip of your knife/blade/etc means scraping that blackness off the glass.

Bear in mind that you *must* use force to get the glass off the display, but the more force you use, the more likely you are to injure yourself, the glass, or both.

Also: it's not explicitly stated, but you must save as much of that old glue as possible, because that's what keeps the new display in place. No replacement glue is offered.

Everything else about the installation is very easy: open up, undo two screws, unplug. Really. That's it. Taking the glass off the old display is 80% of the job; once you get that done (and despite being a sweaty nerve-wracking experience, I did manage it), you simply reassemble and -- voila! -- nicely lit screen. oooooo!

Just got a TX7 last month, and I'd like to backlight that as well. But doing the DX21 was so uncomfortable, I hesitate ... Maybe it was just that one unit that was particularly difficult ....

Don't worry about it, the TX7 is just a matter of 2 screws, no glue and stuff like this! the only trick is to remove the 4 plastic rivets of the metal brackets and re-use them with the new display..