View Single Post
Old 4th August 2019
  #44
Lives for gear
 

Quote:
Originally Posted by Samc View Post
Understood, try the other suggestion of mixing in the live room with headphones/IEMs, the problem might only exist (or is worse) in the box/control room, especially since the main offending instruments are not even in the PA. This fact suggests vibration and not loudness is the problem, and stop vibration you need to isolate, and something tells me that a recording truck or major construction is not going to happen tomorrow.
Quote:
Originally Posted by deedeeyeah View Post
...which tells us that the issues of this specific cr are of structural, mechanical and acoustical nature and should get addressed on those levels, possibly with a combination of several measures before trying electrical means (all of which got nothing to do with small vs large venues, minimal vs massive use of gear or americana vs other genre!)

carpet, isolation mats to dampen vibrations, gobos, diffusors, corner traps etc. - maybe this thread should get moved to the studio building forum then...
Quote:
Originally Posted by studer58 View Post
Agree, especially if the issue occurs repeatedly across several bands and concerts and isn't just confined to an endemic imbalance within one band's stage/PA sound impacting the CR experience for Brent. It sounds more generic than that, and very likely to be a constructional isolation one....which is where the studio building folks are likely to have a wealth of experience to bear on the issue.
I suspected that this was the situation a few posts back, the problem however is that these situations are generally never simple or inexpensive to solve and will most likely require a lot of mass to lower the vibrating frequency of the CR.