View Single Post
Old 19th November 2018
  #38
Gear Nut
 

Quote:
Originally Posted by Synetos View Post
Great to hear you figured it out. I guess I dont know what to say about no response from support. That has not been my experience.

Even when I ran my RME setup, I did my monitor cues the same way. I always had powerful computers that I could push hard at low latency. I run 48k/64samples or 48/128 depending on what I am doing.

Hope that is useful. Btw- what was the resolution to the routing issue?
Him

Thank you for your attempt to help me. My set up is much simpler as I don't record bands, I only produce myself at the moment, but I cannot figure it out how to have minimal latency.

I solved the setting problem by removing, from the burl soundgrid unit, 2 bumpers they added in the last modules. Basically the computer configuration was all fine.

I think I was not entitled to Waves support as I don't own any of their device, which is really bad, as I anyway own one their licensed soundgrid device.

Cheers