View Single Post
Old 29th November 2017
  #9
Here for the gear
 

Beam me up Scotty

In order to make the center tabletop float on its own instead of constantly using the Force to keep it there I used left over MDF to create support beams.
This may not be the best choice of material but it turned out to be more than sturdy enough and it saved me another trip to the hardware store.
I used a mitre cut to match the beams with the trapezoid tabletop and connected the beams by screwing them on to the tabletop using iron angle sections.

The beams where then connected to the towers using really long screws and voila the table top can float on its own.
Attached Thumbnails
Created my own Studiodesk-20170909_133408.jpg   Created my own Studiodesk-20170912_134414.jpg   Created my own Studiodesk-20170912_211824.jpg   Created my own Studiodesk-20170915_093944.jpg