View Single Post
Old 28th November 2017
  #3
Here for the gear
 

I want to play a game

Sawtime!

With the design ready it was time to start creating the side panels.
I used 18mm MDF which had been pre-cut at the hardwarestore to 1x1 meter square boards.

The goal was to create 4 pairs of exactly the same shapes.
Each pair will later on be glued together resulting in a fat 36mm side panel.
I made a change to the design keeping the back straight instead of sloped so that a topboard can be applied for the monitors.

I used a plunge cut saw with a guiding rail for a precise cut. Because of the circular shape of the saw the inner corners can't be cut out completely using the plunge cut. So for that last bit I used a jigsaw. Here are some pictures of the first sawing exercises hopefully making it al clear:
Attached Thumbnails
Created my own Studiodesk-20170617_141232.jpg   Created my own Studiodesk-20170720_200547.jpg   Created my own Studiodesk-20170616_191042.jpg   Created my own Studiodesk-20170720_201306.jpg