View Single Post
Old 2nd October 2017
Lives for gear
jazzcabbage's Avatar

Originally Posted by Bushman View Post
I've never seen or heard of one being used on a microphone cable.
I use them all the time. I think I might have got the idea here? You put one down right at the end butted up against the male xlr. Makes a ribbon mic free of EMI/EMF noise which is a big part of typical ribbon mic noise equation and does not effect the tone unless you like noisy mics?

That link was just an example. You have to size them up to the cable outer diameter because they come in a number of inner diameter sizes. I used to cut the mic cable lengths short and have the preamp sitting as close to the ribbon mic as possible. I've not felt the need to do that since using these.