View Single Post
Old 30th September 2016
  #11
Gear Maniac
 

Hi SmokeyJazz,

It's great to hear that you're enjoying using your Red 4Pre/RedNet rig! To clarify a few points for you/the thread:

- You can connect multiple Dante devices to a switch along with the Red 4Pre, then route up to 32 channels I/O to/from the 4Pre using Dante Controller. In this setup, the 4Pre is essentially doing the same job as a PCIe card or DVS. You can still use all of the other channels on the Red 4Pre when doing this.
- On both the Red 4Pre and Red 8Pre, there are a maximum of 32 Dante inputs/outputs, routable from Dante Controller.
- At present it's not possible to control the Red 4Pre/8Pre from RedNet Control. I will however pass your desire for this functionality on to the development team for consideration as part of future updates.

If you need any more information about any of our products please feel free to get in touch with us here: https://support.focusrite.com/hc/en-gb/requests/new

Best regards,
Jack // Focusrite Technical Support