View Single Post
Old 1st March 2016
Here for the gear

I have one piece of Behringer equipment in my studio and its the Xenyx Control 1 which I use as a monitor switch & controller. I had a Mackie Big Knob and it started going south on me, so I bought this as a stop gap and as it doesn't colour the sound, I've ended up keeping it - a fraction of the cost of a Mackie too.

As long as you don't push the gain on the speaker inputs at the rear, the noise floor is relatively low which is great as I have 23 sets of speakers running through it.

I also have a pair of C2's which I used once and they've been put back in the mic locker for good since. They're not bad as such, just a little tinny sounding.