Apogee Symphony 64 Pcie and PT10
Old 29th November 2013
  #1
Gear addict
 
jac's Avatar
 

Thread Starter
Apogee Symphony 64 Pcie and PT10

I have a Symphony 64 system consisting of 2 DA16-x and 2 Rosetta 800 clocked by a Big Ben.
This rig is mainly used for Logic, but also for Pt (limited to 32 I/O).

The first port 1-32 is connected to the da16-x, the second port 33-64 to the 2 Rosettas.

The rig is rock solid. I have now received a PT10 session at 96khz (I always receive sessions of 44.1 and 48 khz) but I cannot run the session because every time I hit the spacebar I get the following message:

problem detected with audio clock. check that your clock source and sample rate are correct

So i did make some trials and it seems that I cannot go higher than 48khz without getting the message above, so no 88.2, 96 and 192 as well.

I also have an RME AIO pcie card with which my PT works fine.

Any idea about it? I'm surprised that I cannot work at 96khz beside the limited number of i/o. Can somebody suggest a solution?
Old 29th November 2013
  #2
Gear addict
 
jac's Avatar
 

Thread Starter
I did solve the issue by installing the previous apogee symphony driver. Tomorrow will install the new one and will see if it will still give the same problem.
Post Reply

Welcome to Gearslutz Pro Audio Forum!

Registration benefits include:
  • Ability to make and reply to posts
  • Access to members-only giveaways & competitions
  • Interact with VIP industry experts in our guest Q&As
  • Access to members-only sub forum discussions
  • Access to members-only Chat Room
  • Get instant lifetime access to the world's best private pro audio Classifieds for only USD $20
  • List your eBay auctions for free
  • Remove this message!
You need an account to post a reply. Create a username and password below and an account will be created and your post entered.


 
 
Slide to join now Processing…
Thread Tools
Search this Thread
Search this Thread:

Advanced Search
Forum Jump
 
Register FAQ Search Today's Posts Mark Forums Read Search