Gearslutz

Gearslutz (https://www.gearslutz.com/board/)
-   Studio Building / Acoustics (https://www.gearslutz.com/board/studio-building-acoustics/)
-   -   Is there a minimum effective width for BAD panels? And when do I need the inverse? (https://www.gearslutz.com/board/studio-building-acoustics/1316475-there-minimum-effective-width-bad-panels-when-do-i-need-inverse.html)

logjamparty 26th June 2020 08:02 PM

Is there a minimum effective width for BAD panels? And when do I need the inverse?
 
Would like to retrofit some absorption panels in my live room with BAD diffusors. Panels are 2" thick 703, 24" wide 96" tall (61cm x 244cm). Wasn't sure if 24" wide is too narrow, and not sure how many inverses or different patterns I need. There will be a total of 9 panels that I'm retrofitting in a room that's 26' long, 18' wide, 12' ceilings (8m,5.5m,3.6m). The panels will be hanging on the long walls - some of them directly across from each other, some of them staggered.

I've found some templates in this forum, but most of them look 48"x48", mirrored down the center. I wasn't sure if I could chop that template down the middle and stack it to create a template 24"x96". there will be a total of 9 panels that I'm retrofitting in a room that's 26' long, 18' wide, 12' ceilings. The panels will be hanging on the long walls - some of them directly across from each other, some of them staggered.

Planning on 12mm holes based on my research.

Jason Foi 27th June 2020 02:39 AM

Diffusion scatter plates - why does nobody sell them?