Gearslutz

Gearslutz (https://www.gearslutz.com/board/)
-   Geekslutz Forum (https://www.gearslutz.com/board/geekslutz-forum/)
-   -   DBX 160X pot source (https://www.gearslutz.com/board/geekslutz-forum/1272041-dbx-160x-pot-source.html)

Jarjar 12th July 2019 06:09 PM

DBX 160X pot source
 
Hi all,

I just bought a 160X that needs a new compression ratio pot. Anyone know a source for these or an equivalent part number?

Thanks

tINY 12th July 2019 07:24 PM


Is it a linear or audio taper pot? Value? PCB mounted or wired?

Do you have a picture?

Maybe you should take it to a repair shop......



-tINY


Jarjar 13th July 2019 09:26 PM

Thanks for the reply!

Here is a photo from the Studio Electronics site

https://www.studioelectronics.biz/su..._detail&p=1330

I can solder this in easy enough...just looking for another source

Cheers

tINY 15th July 2019 06:52 PM

https://www.mouser.com/datasheet/2/54/0-777299.pdf


This might work.



-tINY


Jim Williams 16th July 2019 08:55 PM

Digi-Key still sells the CTS mini pots that would fit in there. Linear taper only.

Jarjar 17th July 2019 05:28 PM

Thanks very much...I will have a look at the site

Cheers

Brian

rfreeman 8th August 2020 12:08 AM

I'm also trying to replace the ratio pot on the 160xt. Thinking I would make things straight forward I decided to order the part from studio electronics referenced above. Ended up $40 or so after shipping! In the picture it appears to be a direct replacement. Turns out the one I bought only has two legs and not 3 (which wasn't evident from the picture). I have a limited understanding of pots so forgive me if it's ignorant to ask if there is a workaround for this. Thanks.


Edit:
Did a little due diligence on pots. I guess the real question is whether the ratio knob will work okay as a VR rather than a voltage splitter. It baffles me a bit that the VR I received is an EXACT match for the Gain and Threshold pots except the lack of ground. I have a schematic but I am not proficient at reading it. The third missing terminal connection on the board has a trace attached but I am uncertain whether it goes anywhere besides direct ground. Another question would be if either the Gain or Threshold would work okay with the VR. Then I could swap on out and move it to the Ratio position.

Much appreciated