The No.1 Website for Pro Audio
 All  This Thread  Reviews  Gear Database  Gear for sale     Latest  Trending
power amps
Old 10th July 2019
  #1
Here for the gear
 

power amps

Hi everyone, i'm new here. i have a question, can anyone tell me what a power amp is used for? and how do they work
Old 10th July 2019
  #2
Gear Addict
 

For powering passive monitors.
Old 11th July 2019
  #3
not to sound like a smart ass, but a power amp takes a quiet signal and makes it loud. As Dave above explains, a line out signal is very quiet and a power amp takes it and steps it up to make it audible.

If you plug in a set of headphones into a guitar, you probably won't hear anything. But, plug that guitar into a guitar amp and it amplifies the signal so it can be heard.
Old 13th July 2019
  #4
Lives for gear
 

Power amps take a line-level signal and amplify it to drive passive monitors. Consoles, tape decks, compressors, EQs, and mic pre's all have line-level outputs. As power amps generally don't have volume controls, you control the volume from whatever gear is upstream.

A line-level signal is typically 0.75 V for unbalanced (RCA) connectors, or 1.5 V for balanced (XLR) connectors. Power amps have high input impedance so they don't load, or impinge on the output of the upstream gear.

They are designed to drive passive monitors, which typically have a nominal input impedance somewhere between 4-16 ohms. Impedance varies with frequency, sometimes wildly. Sometimes it's good to know the minimum input impedance of a monitor, especially if your power amp is unstable into a low-impedance load.

As monitors' efficiency, or sensitivity, varies widely, some do well with low-powered amps, and others require lots of power. Power is typically spec'd as "x" watts rms (average) into an 8-ohm load. The spec can be more meaningful if it includes the total harmonic distortion (THD) figure, and if it includes the frequency range, typically 20-20,000 Hz. The key is the rms watt output into a specified input impedance.

When selecting a power amp for a specific monitor, make sure it has enough power so you never approach its limits. All power amps can output far more power than their specs suggest, though it's highly distorted. That's how low-powered amps can fry tweeters. The guideline is: have plenty of power on hand, and don't turn it up too loud.

Pic is a mono tube amp that has both RCA and XLR inputs.

WW
Attached Thumbnails
power amps-snapper-rear.jpg  

Last edited by Bill Way; 13th July 2019 at 08:39 PM..
Post Reply

Welcome to the Gearslutz Pro Audio Community!

Registration benefits include:
  • The ability to reply to and create new discussions
  • Access to members-only giveaways & competitions
  • Interact with VIP industry experts in our guest Q&As
  • Access to members-only sub forum discussions
  • Access to members-only Chat Room
  • Get INSTANT ACCESS to the world's best private pro audio Classifieds for only USD $20/year
  • Promote your eBay auctions and Reverb.com listings for free
  • Remove this message!
You need an account to post a reply. Create a username and password below and an account will be created and your post entered.


 
 
Slide to join now Processing…
Thread Tools
Search this Thread
Search this Thread:

Advanced Search
Forum Jump
Forum Jump