The No.1 Website for Pro Audio
Weber W022772 Power Transformer for Vibro Champ
Old 2 weeks ago
  #1
Gear Head
 

Weber W022772 Power Transformer for Vibro Champ

So I'm replacing a blown power transformer in a 79 Fender Vibro Champ that my friend cooked when he put a 6v6 in the wrong way(key was broken off and he didn't see).

A couple of questions here.

On the original transformer there were Green/Black, Yellow/Black, and Red/Black leads. Green/Black was going to the power switch along with the common black wire.

The Yellow/Black and Red/Black are going to the 'death' cap & to chassis. The only information I've found regarding these colors after scrounging online was from the Bronco Schematic, which I believe now is the same as late 70's Vibro Champs. It seems they are other inputs for 240V(234V) international connections. Green/Black was for 120V(117V) Can anyone confirm this is the case? See attached PDF.

See attached pictures for Weber Transformer wires.

The Weber has a lot more leads than the original that was in the amp. It does have a 120V input AND a 125V input. I have Wire 3, the 125V Blue wire and Wire 1 Black Common going to the power switch. I have Wires 4 & 8 Red 660V wires going to the plates of the 5Y3 rectifier tube. I have Wires 12 &13 Yellow 5V heaters going to heaters of 5Y3. I have Wires 9 & 11 6.3V heaters wired in the original way(not twisted pair sorry) with one end grounded to chassis and the other to the pilot lamp & all heaters as called for in the schematic.

The Weber also has a center tap off the 6.3V section Wire 10 Green/Yellow that the original does NOT have. Would I just clip this wire and tape off the end?

The Weber has Wires 5(red/white), 6(red/yellow), 7(red/white) as 600V with a center tap. Would I just clip these and tape them off?

As for the 120V input Wire 2 Brown, would I run this to the death cap and chassis like the international 240V unused inputs were on the original? Or should I just clip it off and tape it too? Is there a point behind tying these to ground?
Attached Thumbnails
Weber W022772 Power Transformer for Vibro Champ-screen-shot-2020-01-11-4.56.32-pm.jpg   Weber W022772 Power Transformer for Vibro Champ-screen-shot-2020-01-11-10.57.35-pm.jpg  
Attached Files
File Type: pdf bronco_ab764_schem.pdf (41.4 KB, 5 views)
Post Reply

Welcome to the Gearslutz Pro Audio Community!

Registration benefits include:
  • The ability to reply to and create new discussions
  • Access to members-only giveaways & competitions
  • Interact with VIP industry experts in our guest Q&As
  • Access to members-only sub forum discussions
  • Access to members-only Chat Room
  • Get INSTANT ACCESS to the world's best private pro audio Classifieds for only USD $20/year
  • Promote your eBay auctions and Reverb.com listings for free
  • Remove this message!
You need an account to post a reply. Create a username and password below and an account will be created and your post entered.


 
 
Slide to join now Processing…
Thread Tools
Search this Thread
Search this Thread:

Advanced Search
Forum Jump
Forum Jump