The No.1 Website for Pro Audio
Otari mx5050 capstan motor TACH
Old 30th September 2019
  #1
Here for the gear
Otari mx5050 capstan motor TACH

the capstan motor on my Otari locked up, when I opened the motor casing, a small plastic piece fell out, motor spins fine, that piece looks like it has a LED on it, there are three of them on the sensor,
two are off, trying to figure out where they need to be glued back,
anyone have pictures
Old 11th October 2019
  #2
Here for the gear
here is a picture of the 'sensor' with one 'chip'
Attached Thumbnails
Otari mx5050 capstan motor TACH-otarit4.jpg  
Old 12th October 2019
  #3
Lives for gear
 
Richard Crowley's Avatar
That looks just like a tape head (perhaps a small "mono" tape head in a cassette machine).
It likely "reads" a magnetic pattern around the flywheel (or some other very close rotating part).
And the signal from that head is what feeds the speed control of the motor.
So that the speed control circuit knows exactly how fast the capstan is rotating.

That little piece off to the right (with the green coil of wire) looks like what is inside a tape head.
A couple of protruding pole pieces and a coil of wire. That is basically what any tape head consists of.

If you had mentioned the model number of your machine (or the motor) we might have been able to offer more help.
Old 12th October 2019
  #4
Here for the gear
 

see Michael's web page, it describes exactly your problem.
http://www.analogrules.com/mx5050.html

start looking for a new motor or George at Athan can rebuild it for $300

oops, Note: Rebuild does NOT include replacement of damaged coil assembly. Additional charge applies.

you'll also get the surface of the shaft redone which is a very good thing.
a new pinch roller and a non shiny capstan surface will help your deck run with lower wow and flutter.

Cheers
Alan

oh, and yes, that is a tape head that reads hte outside tach on the motor for speed control. the other piece is part of the drive assembly and needs exact alignment. It will cog without correct alignment.
Old 13th October 2019
  #5
Here for the gear
thanks , yes I see the tape head but the black 'coil' along with 2 others (one still on that part) have fallen off where they fit exactly is the question
as far as model number all it says is MX5050 , serial number is 177,,, heard the 2nd two numbers indicate the year made ??

Think its time to dig out the Ampex's
Old 1 week ago
  #6
Here for the gear
 

Same thing happened to me on a MX5050 B ll. The rotor and stator are beautiful. Did anyone ever experience a H M S counter that counted negative either way it was turning? (In both directions?)
Post Reply

Welcome to the Gearslutz Pro Audio Community!

Registration benefits include:
  • The ability to reply to and create new discussions
  • Access to members-only giveaways & competitions
  • Interact with VIP industry experts in our guest Q&As
  • Access to members-only sub forum discussions
  • Access to members-only Chat Room
  • Get INSTANT ACCESS to the world's best private pro audio Classifieds for only USD $20/year
  • Promote your eBay auctions and Reverb.com listings for free
  • Remove this message!
You need an account to post a reply. Create a username and password below and an account will be created and your post entered.


 
 
Slide to join now Processing…
Search this Thread
Search this Thread:

Advanced Search
Forum Jump
Forum Jump