The No.1 Website for Pro Audio

Supported By Thomann
Thread / Thread Starter Replies / Views Last Post
Avatar for aciiid

hey guys, i got my hands really cheap on a Boss BX 16 without a PSU. so my goal is to find a PSU to get the mixer...

replies: 0 views: 51
Avatar for aciiid
aciiid 13 hours ago
Avatar for artao

IDK if this is the proper sub-forum for this, but it's the closest I could find for addressing this problem. So I've got an older...

replies: 1 views: 185
Avatar for Rick Dalton
Rick Dalton 2 days ago
Avatar for Nico Zottos

Hey guys, This is a complete noob question but I'm planning out my studio layout and there's one little thing I can't figure...

Nico Zottos
replies: 6 views: 1,188
Avatar for zjrt02
zjrt02 2 days ago
Avatar for jetam

Adam Hall VR 1616 and VR2020 are good but at €1.5 a piece quite expensive. Canford also makes good ones, but they are even...

replies: 3 views: 129
Avatar for Audeath
Audeath 3 days ago
Avatar for sbharrison

Hi there I want to convert an aviation headset (eg David Clark H10 series) to use for it’s headphones + microphone...

replies: 3 views: 467
Avatar for WYWStudio
WYWStudio 3 days ago
Avatar for rocknpop

I’m trying to connect the following gear (outputs): - a Kemper digital out SPIDF (RCA Cable type) - a Yamaha es7 either a)...

replies: 1 views: 128
Avatar for shabbyroad
shabbyroad 4 days ago
Avatar for armandhammer

I've done my research on this (really), read the Rane "Note 110", and I'm not getting the expected results. Here's the...

replies: 12 views: 240
Avatar for armandhammer
armandhammer 5 days ago
Avatar for Bonzo4880

My current snake is 16x8 50' from Seismic Audio. Not the highest quality but has served me well over the last two years. I am...

replies: 0 views: 66
Avatar for Bonzo4880
Bonzo4880 5 days ago
Avatar for boydirtsnow2000

Hi everyone, I bought a BX-8 mixer just a couple days ago and I don't have the power supply for it. I'm desperately looking...

replies: 0 views: 98
Avatar for boydirtsnow2000
boydirtsnow2000 1 week ago
Avatar for Urbane Gorilla

Hi, I was hoping someone could help me with this. I'm pretty new to this, but I've been in the market for a mixer and I picked up...

Urbane Gorilla
replies: 3 views: 2,493
Avatar for boydirtsnow2000
boydirtsnow2000 1 week ago
Avatar for dannydawiz

How do I connect these?

replies: 2 views: 145
Avatar for Cabirio
Cabirio 1 week ago
Avatar for mattcoffay

Hey all, I've been reading these forums for a while--thank you everyone for all of the great info--but this is my first post. ...

replies: 18 views: 19,938
Avatar for makasi
makasi 1 week ago
Avatar for cafeprovence

Hi all, My power amp has blown, so I'll be getting some near gear, and was hoping to be able to use my sub in my new setup. At...

replies: 1 views: 89
Avatar for DrewE
DrewE 1 week ago
Avatar for upekah

Hi, I have a Roland M16e and I can use the return output of each channel to function as an individual output (going out...

replies: 4 views: 191
Avatar for upekah
upekah 2 weeks ago
Avatar for orangefridge

Hi all, I’m considering purchasing the Genelec 8351’s. I’m currently coming out my dangerous source analog XLR to my...

replies: 13 views: 3,522
Avatar for tiagoabrahao
tiagoabrahao 2 weeks ago
Avatar for marksquier

Probably a really stupid question, but how do I connect my monitor speakers to the Digidesign 192? It has the DB25 analog...

replies: 5 views: 1,067
Avatar for RLR0000
RLR0000 2 weeks ago
Avatar for MarcB

I need a stack of extra screws for a couple of Spider MRS-A13/7u stands. Can't find a manufacturer online, contacted Stagg...

replies: 0 views: 95
Avatar for MarcB
MarcB 2 weeks ago
Avatar for qkrzazzang

I’m trying to buy cables for monitor speakers and condenser mic. Im looking into mogami cables and Im very confused about...

replies: 12 views: 2,933
Avatar for bowzin
bowzin 2 weeks ago
Avatar for JollyB

Hey, Quick one; How do I connect an iPhone X to my Rockit RP5. I’ve looked across the internet but seemly can’t find a...

replies: 5 views: 893
Avatar for JollyB
JollyB 2 weeks ago
Avatar for SoNQ

Hey guys, Its my first post here, inspired by a maddening scenario I've found myself in. I have an audio-technica AT2022 XY...

replies: 2 views: 155
Avatar for SoNQ
SoNQ 2 weeks ago
Avatar for ayskura

Hi My mixer is lacking a polarity (Aka phase) switch, I saw some cables that do just that: invert the hot and cold making...

replies: 3 views: 146
Avatar for Speedskater
Speedskater 2 weeks ago
Avatar for 3rds

Hey guys, I have an Avantone ordered for monitoring in mono. After looking around for best way to hook things up, it seems a lot...

replies: 3 views: 110
Avatar for Richard Crowley
Richard Crowley 3 weeks ago
Avatar for Blindekinder

Hi! I bought a M2D2 preamp to complete the two preamps of my 744. I want to connect it in AES, since SX converters are so...

replies: 2 views: 156
Avatar for Richard Crowley
Richard Crowley 3 weeks ago
Avatar for Squeeble

I have a rode PSA1 desk mount, which is tension balanced and can't be adjusted. Recently I upgraded to a shotgun mic which weighs...

replies: 1 views: 122
Avatar for Richard Crowley
Richard Crowley 3 weeks ago
Avatar for badger17

Hi all, I tried this in the main forum, but without much luck, so I'm trying here instead. I'm hoping you can give me some...

replies: 14 views: 2,860
Avatar for Richard Crowley
Richard Crowley 3 weeks ago
Avatar for beyerman

Hi, considering replacing...

replies: 2 views: 238
Avatar for Richard Crowley
Richard Crowley 3 weeks ago
Avatar for jcxjr

I just purchased a Yamaha CX-A5200 Av amp. My old speakers are connected with 14ga. speaker wire, how do I connect them to the...

replies: 4 views: 397
Avatar for Richard Crowley
Richard Crowley 3 weeks ago
Avatar for Jaybird

normalized or half? I have two racks of garage sell 90's and 80's junk. I want to patch these up or loop or link... All...

replies: 17 views: 5,325
Avatar for Richard Crowley
Richard Crowley 3 weeks ago
Avatar for CanadaSC1

I have a set of large speaker monitors, looking to change the cable between the speakers and the amps. This may sound...

replies: 5 views: 212
Avatar for Richard Crowley
Richard Crowley 3 weeks ago
Avatar for ykgs

Hello, I have a Scarlett 4i4 audio interface at home and I'd like to connect it to an old Harbinger M60 PA system I had lying...

replies: 6 views: 172
Avatar for ykgs
ykgs 3 weeks ago
Avatar for jbraney97

Hi all, I have a Steinberg UR22 mkII setup with my Windows 10 PC. I have all the latest driver and firmware upgrades to the...

replies: 5 views: 2,977
Avatar for autoexec.bat
autoexec.bat 3 weeks ago
Avatar for givdog

Hi folks, Sorry if this isn't in the right place.... Also, this might have an obvious answer, or it may be impossible. Go easy...

replies: 1 views: 119
Avatar for pr0gr4m
pr0gr4m 3 weeks ago
Avatar for mariashka

Hi, I'd love some help! I'm alone here in the quarantine, trying to make my studio COME ALIVE. I have a Moog Grandmother...

replies: 3 views: 109
Avatar for mariashka
mariashka 4 weeks ago
Avatar for fendy323

Hello sir, im new in the music world last time i bought topping a90 and d90 and now have a little problems choosing the right xlr...

replies: 4 views: 220
Avatar for DrewE
DrewE 4 weeks ago
Avatar for Layman

Hi all, I am experiencing some confusion with this setup. My digital keyboard has one phones/out. I would've assumed that if I...

replies: 7 views: 1,509
Avatar for TikkoRome
TikkoRome 6th July 2020
Avatar for penbucket

Currently trying to record an album with an Apollo Twin MkII and Focusrite Clarett 8Pre X connected through ADAT with an SR of...

replies: 1 views: 145
Avatar for TikkoRome
TikkoRome 6th July 2020
Avatar for Syphax

I wasn't quite sure where to post this. Behringer's help board isnt very responsive. USING: Behringer FCA1616 to PC via...

replies: 1 views: 100
Avatar for Syphax
Syphax 3rd July 2020
Avatar for gettingbetterpal

Ive been studying converters and plugins for years. I will don't know what Im doing. But Im reaching out to one and all for your...

replies: 0 views: 129
Avatar for gettingbetterpal
gettingbetterpal 1st July 2020
Avatar for neoking

Hi guys, I have like 10 analog synths and drumcomputers which I want to use with eachother on the fly for DAWless jams just for...

replies: 0 views: 172
Avatar for neoking
neoking 28th June 2020
Avatar for Microsuze

Hi. I was not sure what was the best cable to use for connecting the Focusrite Scarlett to these speakers. At the moment using...

replies: 3 views: 1,924
Avatar for sable1
sable1 22nd June 2020
Avatar for elimcg

I’m looking at the Sound Tools Wall CAT. They seem to be unavailable in the UK. Is there an equivalent available for purchase...

replies: 1 views: 204
Avatar for DrewE
DrewE 20th June 2020
Avatar for The Mule

Whenever I do some rearranging in one of my audio racks, whether I'm adding a piece of gear, moving stuff around or whatever,...

The Mule
replies: 6 views: 235
Avatar for Phil Cibley
Phil Cibley 17th June 2020
Avatar for Quint

(FYI, scroll to the bottom of this post for my actual question if you don't want to read the preface info.) I have six 96pt TT...

replies: 0 views: 143
Avatar for Quint
Quint 17th June 2020
replies: 0 views: 140
Avatar for Quint
Quint 16th June 2020
Avatar for mrscratch

Hi all, I am the proud new owner of an Akai s1100. However it is a Japanese model so 100v. I have found a transformer but my...

replies: 5 views: 969
Avatar for Sense_A
Sense_A 16th June 2020
Avatar for janiq

Wondering if someone can help. I am struggling with finding the right adat cable for my audient 800 asp preamp. Bought the usual...

replies: 0 views: 199
Avatar for janiq
janiq 15th June 2020
replies: 0 views: 127
Avatar for Bloodrobin
Bloodrobin 15th June 2020
Avatar for gearhoe

Hi. I am going to be making some XLR, TRS and TS cables, and off-course need to solder the connectors. I need some help finding...

replies: 59 views: 7,676
Avatar for mrfantastic
mrfantastic 15th June 2020
Avatar for Sweetsound

Hi all An easy question mostly that I should be able to answer but I'm out of the loop for too long. I have found a nice...

replies: 3 views: 175
Avatar for Cabirio
Cabirio 14th June 2020
Avatar for WhiskeyWhiskers

Am I wrong for thinking Gotham GAC-1 Ultra Pro and Hosa CGK, both around 20pF/ft would be better (in the objective sense of...

replies: 1 views: 143
Avatar for Speedskater
Speedskater 12th June 2020


Forum Tools
Search this Forum
Search this Forum :

Advanced Search