The No.1 Website for Pro Audio
Thread / Thread Starter Replies / Views Last Post
Avatar for Jason Poulin

My dad and I are fed up with peaks and null in the mix and tracking room in our studio. We've decided to build 24 - 2'X4'...

Jason Poulin
replies: 137 views: 182,655
Avatar for johannburkard
johannburkard 29th August 2018
Avatar for Cojo

Hi! There seems to be alot of talk about bass trapping on the board right now so I thought it was a good idea to post some...

replies: 1,359 views: 1,061,836
Avatar for Pteradactylist
Pteradactylist 7th December 2017
Avatar for jeremycox

Today i started a project to build some quadratic residue diffusers. Overall not a difficult project--even though i used only...

replies: 121 views: 189,694
Avatar for philsaudio
philsaudio 21st February 2017
Avatar for glorycloud

After reading many, many acoustic treatment threads, I've noticed what appears to be a general preference for broadband low...

replies: 3 views: 80
Avatar for glorycloud
glorycloud 44 minutes ago
Avatar for audiovisceral

After several threads here on the relative safety of rockwool, fiberglass, and organic fibers, I did a few days of digging...

replies: 101 views: 157,241
Avatar for avare
avare 12 hours ago
Avatar for mat_down_under

TL;DR: I need help deciding what sort of acoustic treatment I should use in my square room (3.5m x 3.5m, 2.5m H), I don't want to...

replies: 11 views: 176
Avatar for dinococcus
dinococcus 2 days ago
Avatar for Barncore

What's the best insulation measurements? (choose one) 1. 160mm thickness, 48kg/m3 density 2. 160mm thickness, 32kg/m3...

replies: 1 views: 119
Avatar for avare
avare 4 days ago
Avatar for scannedlife

I just ordered three 4 inch thick 24" x 48" ATS acoustic panels. Are there stands out there that would work for with...

replies: 3 views: 127
Avatar for nosebleedaudio
nosebleedaudio 1 week ago
Avatar for airmate

hello, on the weekend i finally finished my latest DIY room acoustics project. due to the absolutely great improvement the...

replies: 150 views: 122,177
Avatar for Samuelito
Samuelito 1 week ago
Avatar for cashhigh

Hey there gearslutz I am a little lost as to where to go from here. I have a room with 5 corners which I have built floor to...

replies: 1 views: 112
Avatar for cashhigh
cashhigh 1 week ago
Avatar for Tim Farrant

Over the years I have had great success fixing smallish room bass problems with limp mass absorbers. As there are so many...

Tim Farrant
replies: 988 views: 395,086
Avatar for oriweissman
oriweissman 1 week ago
Avatar for DreamWalker

Hello all! I have been lurking here and on the JS forum for a number of months while designing and building my electronic music...

replies: 4 views: 642
Avatar for Lewis Robertson
Lewis Robertson 1 week ago
Avatar for RockstarWizkidd

I need to isolate my monitors from my desk. In an ideal world, things would be different, but I have a height constraint...

replies: 0 views: 101
Avatar for RockstarWizkidd
RockstarWizkidd 1 week ago
Avatar for Ipspam

Hi All, long time lurker, first time poster. There is NOT a specific problem I am trying to fix, and therefore no pretty...

replies: 4 views: 263
Avatar for IEC
IEC 2 weeks ago
Avatar for DownSideUp

Hey all ! I found this video and his back wall looks amazing. I'd be curious if the pattern of the walls are random or...

replies: 1 views: 157
Avatar for SkyWriter
SkyWriter 2 weeks ago
Avatar for PaulMac

I've just installed lots of 10cm and 5cm thick panels to the walls in my control room, as well as GIK bass traps in the corners....

replies: 0 views: 162
Avatar for PaulMac
PaulMac 2 weeks ago
Avatar for DaveNJ

Hey all, I'm moving my home studio from an extra bedroom to the basement. Good news - I gain 20' in length and 2' in width, but I...

replies: 8 views: 1,088
Avatar for WJohnston
WJohnston 2 weeks ago
Avatar for lyonsno

Hi everyone, first time poster here. EDIT: tldr is that I bought some used low range monster bass traps and the previous owner...

replies: 0 views: 135
Avatar for lyonsno
lyonsno 3 weeks ago
Avatar for captaink

Hi I have just bought a house and my studio is in a small room which is 2m W x 3m L x 2.5 H. I am looking to treat it and have...

replies: 10 views: 296
Avatar for Jens Eklund
Jens Eklund 3 weeks ago
Avatar for dasnub

It seems to be conventional wisdom that we keep our monitors set up vertically- the reasoning being that we are more likely to...

replies: 15 views: 6,000
Avatar for Jens Eklund
Jens Eklund 3 weeks ago
Avatar for travelboy

My room needs more treatment for absorbing very low frequencies. I have a cabinet covering one wall. I thought about putting bass...

replies: 5 views: 2,501
Avatar for lahatte
lahatte 3 weeks ago
Avatar for Maschu

Hey guys, I'm in the process of recording vocals for my first album and therefore facing a couple of problems: 1. my studio is...

replies: 10 views: 269
Avatar for slaves666
slaves666 4 weeks ago
Avatar for Rick Sanchez

I have a number of Owens Corning 703 panels and a partial bolt of Guilford fabric left from a previous project. Has anyone...

Rick Sanchez
replies: 20 views: 8,116
Avatar for eightinchninja
eightinchninja 4 weeks ago
Avatar for canadianaudioboi

Hello once again this is canadian audio boi looking for some advice. The only options i have here in canada are primacoustic,...

replies: 2 views: 229
Avatar for kgveteran
kgveteran 4 weeks ago
Avatar for IEC

Hey, I am about to purchase some material for bass trapping/treatment in my room. They are semi rigid poly batts that will be...

replies: 0 views: 144
Avatar for IEC
IEC 4 weeks ago
Avatar for Stormchild

To avoid wasting everyone's time, I'll just start with a few basic facts that will probably grind this conversation to a halt...

replies: 25 views: 378
Avatar for Stormchild
Stormchild 4 weeks ago
Avatar for canadianaudioboi

Hey its canadian audio boi. I want a DEAD room dead and dull. Cant treat the ceiling. But i can get a huge...

replies: 0 views: 126
Avatar for canadianaudioboi
canadianaudioboi 4 weeks ago
Avatar for Rtroost

Hi- Im planning on treating most of the back wall of my new studio (will set up a build thread on it once I can get on site...

replies: 4 views: 227
Avatar for Rtroost
Rtroost 20th April 2020
Avatar for Carl1988

Hello everyone, I want to threat rear wall with 120cm depth of glass wool. Which density do I use ? 8 kg/m^3 , 10 kg/m^3 , 16 ...

replies: 6 views: 392
Avatar for alevinai
alevinai 18th April 2020
Avatar for katelyndawn89

Hi there, I've read quite a few posts around this question but can't seem to find a concise answer (I don't speak technical...

replies: 8 views: 567
Avatar for Jens Eklund
Jens Eklund 17th April 2020
Avatar for MarathonMan

I found a local seller who is moving out of the state and who's willing to sell three Primacoustic Full Traps for $300. I...

replies: 14 views: 250
Avatar for thethrillfactor
thethrillfactor 15th April 2020
Avatar for sigmundsuperstar

Hi, do you know where I can find thick foam panels like those in the video? (in Europe) Thanks ...

replies: 4 views: 802
Avatar for Speeddemon
Speeddemon 14th April 2020
Avatar for canadianaudioboi

Hi I am canadian audio boi. I would get real traps but its tough where i live (british columbia) which is why my only choice...

replies: 6 views: 253
Avatar for avare
avare 12th April 2020
Avatar for Alexander_

I have a relatively small room. It's about 4 meters wide and 5 meters long. (13 by 16.5 feet) To treat the room i went out...

replies: 1 views: 204
Avatar for avare
avare 12th April 2020
Avatar for canadianaudioboi

Hello it is canadian audio boi with a third question. I cannot install anything on the ceiling, as it is a popcorn ceiling and...

replies: 0 views: 136
Avatar for canadianaudioboi
canadianaudioboi 12th April 2020
Avatar for canadianaudioboi

Hey its canadian audio boi again. Quick question for the audio experts. I am wondering if there is any acoustic benefit to...

replies: 0 views: 127
Avatar for canadianaudioboi
canadianaudioboi 12th April 2020
Avatar for Chet_Rockstone

Hello everyone, I'm very new to this board and also very new to acoustic treatment but I've been reading the threads here and...

replies: 28 views: 805
Avatar for Chet_Rockstone
Chet_Rockstone 10th April 2020
Avatar for serious steve

Hi guys , I've attached images of the space I've managed to blag at home for my music setup. Do any of you have some ideas...

serious steve
replies: 0 views: 118
Avatar for serious steve
serious steve 8th April 2020
Avatar for VlaVlnPlayer

Hello all, I have the possibility of using this material (picture attached) for free. I thought I could make a few panels for...

replies: 3 views: 223
Avatar for VlaVlnPlayer
VlaVlnPlayer 7th April 2020
Avatar for alphon

Hello there! I would be happy getting some feedback on the following: Is it OK to combine panels in the same array a) which...

replies: 0 views: 170
Avatar for alphon
alphon 3rd April 2020
Avatar for brettman

Greetings all. This is my first acoustics post and I'd love your collective wisdom on the below... I've just built and...

replies: 14 views: 774
Avatar for Jochen Schulz
Jochen Schulz 3rd April 2020
Avatar for 12ax7

I'm just curious: How would a big stack of rolls of toilet paper fare as a makeshift bass trap in...

replies: 6 views: 231
Avatar for 12ax7
12ax7 31st March 2020
Avatar for Mike56

Forum members, experts, I wonder if you can help me? – I am an amateur music listening enthusiast, so please excuse the...

replies: 4 views: 386
Avatar for Mike56
Mike56 31st March 2020
Avatar for LeadingLeo

Hey! I just built some fat super chunk corner bass traps, from floor to ceiling using triangles of Rockwool insulation (30 kg/m3)...

replies: 6 views: 409
Avatar for RobbyPowell
RobbyPowell 31st March 2020
Avatar for RedTone

Hey All, I've done a quick video of my experimentation with moving blankets in my studio I am building. I wanted to tame some...

replies: 20 views: 504
Avatar for chessparov2.0
chessparov2.0 30th March 2020
Avatar for revamped

Hi guys, I recently purchased a number of panels and bass traps for my bedroom studio. The foam is manufactured by dunlop (you...

replies: 10 views: 2,392
Avatar for EpicEsquire
EpicEsquire 25th March 2020
Avatar for G. E.

I've built numerous porous absorbers, membrane absorbers, Helmholtz absorbers, and VPRs within the last years always wondering...

G. E.
replies: 307 views: 87,213
Avatar for Exprymer
Exprymer 24th March 2020
Avatar for arif

Is it good idea to build acoustic panels and bass traps with rebounded foam? Picture:...

replies: 0 views: 183
Avatar for arif
arif 24th March 2020
Avatar for duxsmer

Hello fellow slutz! I'm looking for suggestions for count and placement of bass traps for my home studio/listening room. The room...

replies: 8 views: 1,100
Avatar for Bushman
Bushman 23rd March 2020
Avatar for RedTone

Here is a build thread for the First Reflection Panels for my studio in my shed I am working on. I wanted to have something I...

replies: 8 views: 397
Avatar for johndykstra
johndykstra 23rd March 2020
Avatar for Gadget13769

I have some 50mm thick fibreglass panels to go on my walls. I have been told that fitting these with a 50mm air gap behind...

replies: 42 views: 11,594
Avatar for avare
avare 13th March 2020
Avatar for Mr.E

Plans have changed so I have deleted the text for this and will create a new post. Feel free to delete.

replies: 0 views: 257
Avatar for Mr.E
Mr.E 10th March 2020
Avatar for lonvoc


replies: 0 views: 308
Avatar for lonvoc
lonvoc 9th March 2020


Forum Tools
Search this Forum
Search this Forum :

Advanced Search