We are in the midst of revamping our control room acoustics.. It essentially just used to pretty well be bare. We've started by adding a lot of absorption and then if we are finding it too dead, we can add some paneling or inset diffusers.
Whatevers in red, is yet to be added.
There is one major problem area (blue circle) we have struggled with eliminating, but have narrowed it down - would be great to get some feed back on this area, it's pretty much center room between where the engineer sits, and where the clients sit, but it's a pretty bad flutter.
Also wondering what should go behind the guitars, feel like being at the stage we are now, adding absorption behind the guitars might be too much.
Any tips/comments greatly appreciated. Thanks!