All Advertisers
| All Advertisers |
| |||||||
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| most over rated piece of gear | whitepapagold | So much gear, so little time! | 152 | 20th December 2006 10:36 PM |
| A Little X Rated Audio Porn | 1320 P. | So much gear, so little time! | 7 | 23rd June 2006 05:32 AM |
| Articles on impedance and impedance matching? | dan*leclub | Geekslutz forum | 3 | 25th March 2006 01:16 PM |
| Impedance/Load Questions - Ampex, Millennia preamps, etc. | laoded | So much gear, so little time! | 3 | 27th December 2005 08:26 AM |
 |
| | Thread Tools | Search this Thread | Rate Thread | Display Modes |
25th June 2005, 05:23 PM
| #1 |
| Gear Head  Join Date: Jan 2005 Location: Mallorca - Spain
Posts: 38
| Difference between Rated Impedance & Rated Load Impedance? Hi everybody. I've got a question about microphones. Whats the difference between Rated Impedance & Rated Load Impedance? I've got a mic that has Rated Impedance = 50 Ohms and Rated Load Impedance = 1000 Ohms. And I've got a mic pre-amp with selectable impedances. Which one should I take as reference to use correctly the mic & the pre-amp? Thanx. Saludos. |
|  |
|
25th June 2005, 07:18 PM
| #2 |
| Lives for gear  Join Date: May 2005 Location: Oklahoma City
Posts: 1,022
| Most "modern" mics need to be loaded into a preamp with an input impedance that is considerably higher than the output impedance of the microphone. Hence, in the case you mention, set the preamp to a value close to 1000 Ohms. Bri |
|
| |
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
| |
Linear Mode
