Dear Gentlemen,
i am looking for advoice from the seasoned gods of audio on the issue of splitting
.
the picture is:
i have all my analog comps/eqs and stuff on the patchbay, as well as the i/o of the soundcards etc etc. the usual thing.
until now, i was patching via the bay, using the split moduls to have a monitoring line, which goes to the desk for this purpose.
e.G soundcart out goes to patch>goes to comp> upper tray goes back to soundcard ins, lower tray goes for monitoring.
the path is fully symetrical.
however, i wonder if there is a more better way, more flexible way, and in the end - is this correct. i have never seen a different way of doing it, but - that doesn t falsify any right/wrong doing.
question: how do you do it? what are your opionions ? any advices ? hints ? any funky slutty gear that will boost the quality of splitting at about 1000% ?
all comments and ideas are highly appreciated :-)
thanks for reading !
mark
New Reply 
Facebook
Twitter
LinkedIn
) as patchbay or audio path, thus i have had a hard time in figuring out what the most best thing to do in my situation might be.
