HELP! adat output in ProTools LE 002

marshallplexi · 7th March 2007, 10:14 AM

How do i set up the ADAT output in the 'Setup I/O' section ?

If i click on input, tracks 9 to 16 are labeled Optical, so no problems there.
However there is no Optical section under the Output page.

How do i do ?

Thanks !

amishsixstringe · 7th March 2007, 10:49 AM

I don't think you can go in and out of adat at the same time on the 002, since there's only one cable. If you mean for mixdown purposes, then you're still limited to 9-16 as your channels out, which you would just route your bus outputs to.

Neil

gibsonlp75 · 7th March 2007, 11:03 AM

no, theres are both an adat in and out...

in your I/O, just try hitting the default button and see if it resets it... sounds like its recognizing some old hardware you might have had??

hopefully that will get you fixed!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Adat to 002	johnwayne	So much gear, so little time!	3	8th February 2007 06:18 PM
protools output mirroring	RooF	Music computers	4	1st March 2006 08:19 PM
Problem with OctoPre ADAT output - Help?	SoundChances	Music computers	13	31st July 2005 04:18 AM
ad converter with adat output or isa 428?	maskedman72	So much gear, so little time!	3	9th December 2004 11:11 AM

7th March 2007, 10:14 AM	#1
marshallplexi Gear maniac Join Date: Oct 2006 Posts: 218	HELP! adat output in ProTools LE 002 How do i set up the ADAT output in the 'Setup I/O' section ? If i click on input, tracks 9 to 16 are labeled Optical, so no problems there. However there is no Optical section under the Output page. How do i do ? Thanks !

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

7th March 2007, 10:49 AM	#2
amishsixstringe Gear addict Join Date: Mar 2007 Posts: 422	I don't think you can go in and out of adat at the same time on the 002, since there's only one cable. If you mean for mixdown purposes, then you're still limited to 9-16 as your channels out, which you would just route your bus outputs to. Neil

7th March 2007, 11:03 AM	#3
gibsonlp75 Gear nut Join Date: Nov 2006 Location: Nashville, TN Posts: 144	no, theres are both an adat in and out... in your I/O, just try hitting the default button and see if it resets it... sounds like its recognizing some old hardware you might have had?? hopefully that will get you fixed!