HD24 help

[63hz]

hi, I've somehow managed to alter a setting on my HD24 and i cant see to find a fix in the manual or on the yahoo group.
problem is input 1 is copied to 9 and 17. 2 to 10 and 18
and so, so that inputs 9 and above do not work, it just meters 1-8 three times.
im sure this is a simple fix so any help would be greatly appreciated

[Pat]

Well this will solve your problem

You can choose between five different Input Modes:
2-Input Mode, 4-Input Mode, 8-Input Mode, 12-
Input Mode, and 24-Input Mode. These can provide
five different analog audio input hookup options:
• 2 Bus Mixer: Connect the mixer’s two bus
outputs to the HD24’s INPUTS [1] and [2]. Select
2-Input Mode on the HD24 by holding down
the INPUT SELECT button until the display reads:
Select Audio
Input Tracks
Then press either Track Select buttons [1] or [2];
notice that the INPUT LEDs for tracks 1 and 2
remain lit until you release the INPUT SELECT
button.
• 4 Bus Mixer: Connect the mixer’s four bus
outputs to the HD24’s INPUTS [1] through [4].
Select 4-Input Mode by holding down the INPUT
SELECT button until you’re prompted to select
the tracks; press either Track Select buttons [3]
or [4]. The INPUT LEDs for tracks 1 through 4
remain lit until you release the INPUT SELECT
button.
• 8 Bus Mixer/Direct Outputs: Connect
the mixer’s eight bus outputs (or 8 direct
outputs) to the HD24’s INPUTS [1] through [8].
Select 8-Input Mode by holding the INPUT
SELECT button and pressing any Track Select
button from [5] - [8]. The INPUT LEDs for tracks
1 through 8 remain lit until you release the
INPUT SELECT button.
• 12 Bus Mixer: You’ve got the drill by now,
right? When the display reads “Select
Audio Input Tracks”, press a Track
Select button between 9 and 12, and the lower
inputs will “normal” to the higher tracks (1 to 1
and 13, 2 to 2 and 14, etc.)
• 24 Bus Mixer (or Direct Outs): Same
deal—press INPUT SELECT and press a track 13 or
above to have the “normal” setup with each
track “hearing” its own separate input.
In the first four modes, the HD24 internally
connects the inputs to the higher tracks (for
example, Input 1 goes to tracks 1, 9 and 17 in 8-
Input mode).

[63hz]

thanks pat all solved, i knew it was just one little button i needed to press

[Kyle S]

that button is DEADLY. always make sure its set right before you start recording. otherwise you'll be staring into your meters for a sec wondering why nothing is correlating.

[Remoteness]

I prefer operator errors to technical errors; they are usually easier to fix.