Logic Q: Starting Point of Bounce in SMPTE

Trp · 17th May 2006

Hi there,

I have a question for all LOGIC users:

Is it possible to define start and ending locations as SMPTE-values instead of bars/beats/etc. when bouncing?

Couldn´t find it in any menu.

Thank You!

gsilbers · 17th May 2006

good question,. i was looking for that the oother day.

i just place the 2beep 2 secs before bar 0. then i i know the ending time or duration by placing the line where the project ends and see in the transport the time.

but i dont know to see something that starts at min 3 and see the duration of that untilt the end. besides doing some math in smpte

17th May 2006	#1
Trp Gear addict Joined: Jun 2004 Location: Germany Posts: 315 Thread Starter	Logic Q: Starting Point of Bounce in SMPTE Hi there, I have a question for all LOGIC users: Is it possible to define start and ending locations as SMPTE-values instead of bars/beats/etc. when bouncing? Couldn´t find it in any menu. Thank You!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread starter	Forum	Replies	Last Post
Good starting point for a DIY pre	mesh boogie	So much gear, so little time!	3	1st May 2006 01:34 AM
Logic SMPTE offset	Bump Music	Music computers	0	12th December 2005 08:31 PM
"Starting Point" EQ For Voiceovers	yapz	Low End Theory	10	25th November 2004 08:05 PM
Logic 7 bounce problem.	mac black	Music computers	1	24th October 2004 06:00 PM
Ok. My brain is starting to hurt...lol. Logic or Nuendo?	enharmonic	So much gear, so little time!	16	12th June 2004 12:54 AM

17th May 2006	#2
gsilbers Lives for gear Joined: Jan 2006 Location: El Pueblo de Nuestra Senora La Reina de Los Angeles de Porciuncula Posts: 3,622	good question,. i was looking for that the oother day. i just place the 2beep 2 secs before bar 0. then i i know the ending time or duration by placing the line where the project ends and see in the transport the time. but i dont know to see something that starts at min 3 and see the duration of that untilt the end. besides doing some math in smpte