andygomez

You need to in your case use the buss's and not the direct out. In the menu section there is a page for assigning the physical output to the buss's. I forget exactly what the name of the page is but you need the buss's to say adat/direct out if I remember correctly. This is where you answer is

Thank you for writing me back Andy,

I thought I used the direct button before in one of my trial and error sessions but i guess maybe I was missing a step. I am going into all preamps on the board from outboard preamps and then going out of 8 of the channels analog into my digi003rack and then the other 8 going through adat lightpipe so maybe the complexity of my setup is what is messing me up.

I will check your suggestions the next time I have some trial and error time.

Cheers and thanks again.

hey there Andy,

Just noticed you use the dm3200. I just bought one and have been able to get the signals into the daw and everything and mix with it, but.... I haven't been able to figure out how to get the signals to go out of the console post fader so I can use my faders in tracking... can you possibly tell me what I am doing wrong here?

Thanks.