Amek Rembrandt

[Ciaran_McCreary]

I am trying to calibrate the faders to the supertrue software , I did this once before but cant for the life of me remember how i did it. Not sure is i had to run something from the dos prompt??? not sure ....

[Matt Syson]

Hi
It is in the \suprtrue\system\ directory IIRC. Possibly under 'setup'.
Why do you want to recalibrate the faders / VCAs, have you changed any?
There is a possible problem in that the cal procedure in some revisions has a minor 'hiccup' if you try to calibrate short and long faders all at once so you must do one then the other as for some reason it 'stores' a blank file.
If you do manage to 'break' it, if you delete the faders.cal file or better, rename it to something like (faders.old) it will automatically revert to an internally preset 'idealised' fader calibration, until you manage to get a sensible set of values.
Unless you have swapped modules or faders around it should not be necessary. In fact you don't need to if you swap modules as the electronics is consistent, it is only the fader 'law' that is significantly different.
Matt S

[Matt Syson]

Hi
It is detailed in the manual by the way!
Matt S

[Ciaran_McCreary]

Originally Posted by Matt Syson

Hi
It is detailed in the manual by the way!
Matt S

Hi matt,
thanks for getting back, the reason that i wish to re-calibrate is i have noticed that Zero positions (marked on the consoles surface) ain't lining up with that of the supertrue on one or two faders ..... it's no biggey just bugged me as to why it was happening. I thought I may have calibrated them wrong myself.

the large manual or the supertrue manual (couldnt see it in the supertrue) ?

Thanks Again