Replacing Built-In Juno HS-60 Speakers
Old 29th December 2012
  #1
Gear maniac
 
AuldLangSine's Avatar
 

Thread Starter
Replacing Built-In Juno HS-60 Speakers

Has anyone put new speakers in the HS60 (like a Juno 106 but with built in speakers)? The right speaker has somewhat disintegrated and both should be replaced. I don't see how to remove the particle board housing that the speakers are set in. I hope I am wrong, but it looks like the entire bottom must be removed. Tips on speaker removal and good drop in replacements would be super cool! Thanks!!!
Old 13th July 2013
  #2
Gear maniac
 
3Crystals's Avatar
 

Just remove the 4 screws that hold the speaker in.I need a speaker also.4 ohm's,About 3.5/8's" dia.
Old 20th November 2013
  #3
Gear nut
 
hagbard's Avatar
 

wondering if you guys ever did this? my speakers are shot too. not sure if they are really worth replacing but if you guys found a cheap and decent solution it might be worth it. also i'm wondering if a guy had a juno 106 panel could that be installed on a hs-60 if you removed the speakers?
Topic:
Thread Tools
Search this Thread
Search this Thread:

Advanced Search
Similar Threads
Thread
Thread Starter / Forum
Replies
sethbrand_12 / So much gear, so little time!
34
SK1 / Geekslutz forum
3
dr_von / High end
11
mrbowes / Geekslutz forum
3
etherize / Remote Possibilities in Acoustic Music & Location Recording
4

Forum Jump
 
Register FAQ Search Today's Posts Mark Forums Read

SEO by vBSEO ©2011, Crawlability, Inc.