How hard is it to swap out a microphone capsule? U47 type microphone

DONNX · 1st September 2009, 09:39 AM

Hello everyone,

I am thinking about upgrading one of my U47 clone mics with a M7 capsule instead of the K47 that it comes with. Sounds great. But I really want to hear what the M7 is all about. I know how to solder, do basic electronic stuff, but I am no mic builder. I swapped transformers, capsules, changed tubes, stuff like that..

When looking at the k47 capsule on my Pearlman TM1. Its seems simple and but very fragile to my eye. Few wires and a screw in the center of the capsule. Definitely don't want to touch the membrane of the capsule.

I am thinking how hard can this be? To take out the K47 and install a new M7 in place. And screw in the wire in the center of the capsule and solder the other wires in. Could it be that simple or does this require a mic builder and pro?

Can anyone here with experience contribute some advice and info. I know someone is going to tell me to not mess with it and send it to a pro. If so, how much does it cost for labor and who would you recommend if this task is only for the pros.

Thanks!

mobius.media · 1st September 2009, 10:15 AM

there's some info here you might find helpful
Apex 460 Capsule Mod

1st September 2009, 09:39 AM	#1
DONNX Lives for gear Join Date: Sep 2008 Location: Floatatious Es Groovay! Posts: 3,788	How hard is it to swap out a microphone capsule? U47 type microphone Hello everyone, I am thinking about upgrading one of my U47 clone mics with a M7 capsule instead of the K47 that it comes with. Sounds great. But I really want to hear what the M7 is all about. I know how to solder, do basic electronic stuff, but I am no mic builder. I swapped transformers, capsules, changed tubes, stuff like that.. When looking at the k47 capsule on my Pearlman TM1. Its seems simple and but very fragile to my eye. Few wires and a screw in the center of the capsule. Definitely don't want to touch the membrane of the capsule. I am thinking how hard can this be? To take out the K47 and install a new M7 in place. And screw in the wire in the center of the capsule and solder the other wires in. Could it be that simple or does this require a mic builder and pro? Can anyone here with experience contribute some advice and info. I know someone is going to tell me to not mess with it and send it to a pro. If so, how much does it cost for labor and who would you recommend if this task is only for the pros. Thanks!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
thread	Thread Starter	Forum	Replies	Last Post
Neumann u47 microphone box	jvancorduroy	So much gear, so little time!	0	28th July 2009 12:00 AM
changing microphone capsule	naiox	Low End Theory	0	14th February 2007 12:27 PM
Neumann U47 / Telefunken U47 microphone sound	JOHN	High end	0	27th January 2007 06:31 PM

1st September 2009, 10:15 AM	#2
mobius.media Lives for gear Join Date: Jun 2009 Posts: 1,965	there's some info here you might find helpful Apex 460 Capsule Mod