Replacing Studer A820 VU Meter Bulbs?

[ROGERD]

hello,

I hope this is the right forum for this question. I have the manual but can't find how to change the bulbs for the VU meters on the bridge for a Studer A820.

If anybody can post "how to" do this, I would greatly appreciate any help.

Roger

[ROGERD]

Reference:

Yes, remove the 4 x 2mm button head hex screws, with the power off.
Now pull out the module and behind the meter you will see two screws that
hold a "shroud" assembly up against the meter. Removing only the screws will not
allow you access to the meter lamps. Now here's the tricky part- there are a couple
of plastic tabs that make a pressure fit to keep that shroud in place. You have to
squeeze them together, carefully and gently pull back on that assembly and it will
come off. I say gently because the plastic is now old and it can easily break if you
are to rough with it. You will then see the lamps that just come out of a socket.

Info was provided by Charlie Bolois at Vertigorecording....

Thanks Charlie!