All Advertisers
| All Advertisers |
| |||||||
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Request: Eisen Audio Kit Builders BOM for Archive | aermotor | So much gear, so little time! | 11 | 1st August 2008 03:30 PM |
| Any comments on Avedis 1122 versus SCA SC25 opamps? | corn55 | High end | 7 | 6th August 2007 04:25 PM |
| Raytheon Opamp? | Bassmankr | Geekslutz forum | 27 | 24th January 2007 03:01 AM |
| Opamp | Stitch333 | Geekslutz forum | 2 | 22nd November 2006 05:08 PM |
 |
| | Thread Tools | Search this Thread | Rate Thread | Display Modes |
10th June 2008, 05:09 PM
| #1 |
| Lives for gear  Join Date: Jan 2006 Location: Pittsburgh, PA
Posts: 1,586
 | SC25 Opamp BOM? are these around/available? |
|  |
|
10th June 2008, 05:39 PM
| #2 |
| Gear addict Join Date: May 2006 Location: Northridge, CA
Posts: 332
| Make up your own from the schematic: Seventh Circle Audio |
|
| |
|
11th June 2008, 07:54 AM
| #3 |
| Lives for gear Join Date: Jan 2006 Location: Pittsburgh, PA
Posts: 1,586
| where can i learn how to do that? |
|
| |
|
11th June 2008, 08:15 AM
| #4 |
| Gear maniac  Join Date: Mar 2008
Posts: 166
| Not to be discouraging, but if this is your first endeavor into electronics, this is probably not the best project to start on. The parts to some opamps can be rather expensive and they're rather easy to blow up, and it is possible it could take whatever preamp you put your opamp into with it. My advice for you is to read up on the subject. Get to know a little about the basics before attempting to build something. Then try some guitar pedals or a couple of simpler devices before tackling this one. |
|
| |
|
11th June 2008, 05:55 PM
| #5 |
| Lives for gear Join Date: Jan 2006 Location: Pittsburgh, PA
Posts: 1,586
| this is not my first project  but i am a greenie. i just don't know how to look at a schematic and then know what values parts should be.. if i had a BOM then i'd be just fine. |
|
| |
|
11th June 2008, 07:03 PM
| #6 |
| Lives for gear Join Date: Aug 2004 Location: Santa Fe, NM
Posts: 910
| Ah, Tim didn't actually put the component values in the schematic. I suspect that this was on purpose. You might drop him a line and ask; he's a helpful fellow... |
|
| |
|
11th June 2008, 08:34 PM
| #7 |
| Lives for gear Join Date: Jan 2006 Location: Pittsburgh, PA
Posts: 1,586
| yea i've seen him floating around here i think...anyone have his name so i can PM him? |
|
| |
|
11th June 2008, 09:08 PM
| #8 |
| Lives for gear Join Date: Aug 2004 Location: Santa Fe, NM
Posts: 910
| You can try email at sales (at) seventhcircleaudio.com. |
|
| |
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
| |
Linear Mode
