Gearslutz.com - View Single Post - Loud Burst of White Noise When Opening PT LE Session

jeff deff · 14th October 2006

Hello,

I am running Protools LE v7.1cs8 with a Digi002R on a G5 1.8Ghz mac with OS 10.4.5. Recently when I open sessions a huge, enormously loud burst of white noise that lasts a few seconds occurs. It sounds like it is running through reverb too. It's like someone threw a guitar amp with spring reverb against the wall. The sound is so loud it makes me afraid I will blow out my speakers, not to mention it makes everyone in the room jump as if someone just fired a 357 magnum in the room.

The sessions I am opening are 24 bit 88.2k AIF sessions. Recently I started to use insert buses for reverb. My Dverb plug in will be on a stereo aux input channel, and I will use the bus sends to send audio to this reverb channel. Could this sound be caused by having reverb on a Aux Input channel that is fed by a bus? It is not setup in a feedback loop.

This sound only occurs while a session is starting up. Then everything is fine.
Anyone experience something similar to this?

Thanks
Jeff

14th October 2006	#1
jeff deff Gear nut Joined: Nov 2005 Location: Chicago, Ill. Posts: 130 Thread Starter	Loud Burst of White Noise When Opening PT LE Session Hello, I am running Protools LE v7.1cs8 with a Digi002R on a G5 1.8Ghz mac with OS 10.4.5. Recently when I open sessions a huge, enormously loud burst of white noise that lasts a few seconds occurs. It sounds like it is running through reverb too. It's like someone threw a guitar amp with spring reverb against the wall. The sound is so loud it makes me afraid I will blow out my speakers, not to mention it makes everyone in the room jump as if someone just fired a 357 magnum in the room. The sessions I am opening are 24 bit 88.2k AIF sessions. Recently I started to use insert buses for reverb. My Dverb plug in will be on a stereo aux input channel, and I will use the bus sends to send audio to this reverb channel. Could this sound be caused by having reverb on a Aux Input channel that is fed by a bus? It is not setup in a feedback loop. This sound only occurs while a session is starting up. Then everything is fine. Anyone experience something similar to this? Thanks Jeff