Gearslutz.com - View Single Post - Tube Preamp

contramark · 16th May 2012

Ok i just wanted to clarify

SPX 90II
input - unbalanced
output - unbalanced

Solo 610
input - balanced
output - balanced

So if I run a keyboard into Solo 610, then use a standard XLR to TRS from the Solo 610 to input of SPX90 I get this weird low-end drop output problem. But if i use some test cable clips to swap to use the Tip and Ring (rather than Tip and Sleeve) it works.

So i should use -20 setting on SPX90 for this setup?

16th May 2012	#9
contramark Lives for gear Joined: May 2005 Location: philadelphia, pa Posts: 501 Thread Starter	Ok i just wanted to clarify SPX 90II input - unbalanced output - unbalanced Solo 610 input - balanced output - balanced So if I run a keyboard into Solo 610, then use a standard XLR to TRS from the Solo 610 to input of SPX90 I get this weird low-end drop output problem. But if i use some test cable clips to swap to use the Tip and Ring (rather than Tip and Sleeve) it works. So i should use -20 setting on SPX90 for this setup?