Hey Collo,
I have a question about this:
Quote:
Originally Posted by collo  Here are a few more....
N7+4
N11+4
N13 +2 ..... better mix with N13+6, but not quite same depth
N17+6
N19 +1 ..... better mix with N19+5, but not quite same depth
N23+6 ..... better mix with N23+2, but not quite same depth
N29+11 |
Taking N23+2 (at 135mm MWD), when I switch to Inverse mode, if I go to N23i+4, I get a MWD of 132mm. What do you think of this approach?
Quote:
Originally Posted by collo Good point about being able to split any well...... |
There is a point where it will look strange or weaken the frame, but you could split a well that is say as much as 25% of MWD I think.
I'd like to add another question, related to my build. I am using 3 N23 arrays (plus a 'modulation' array--this is the one I'm not sure on). I plug in my MWD (135mm) into QRDUDE, then toggle to "design frequency", hit "Switch to Inverse Panel" then (here's the trick) reset my "Deepest well" as 135mm, and start scrolling through the Inverse panel permutations. I find that:
N23+0: design freq. = 994Hz = 135mm MWD
N23i+4: design freq. = 1055Hz = 135mm MWD
Design Hz are not that far apart either. Do you think this is a fair application of the Inverse panel in a modulation scheme? If so, it would be a good solution for me.