| 8 * N11's sounds OK.
Your would need to make a couple of them inverses to keep Mr Barker happy.
If you use +4 for the N11's and -4 for the I11's you get them the same depth.
You don't get any zero-depth wells, but I would suggest leaving the right hand wall off all but the last panel. With the foam material you are going to use in the wells, they will seal up when you mount them firmly against each other. Visually, this would look like a single panel.
"Another perhaps small point is that if one is able to arrange zero wells across the frames you are actually getting 100% QRD across the entire array"
I'm not sure what you meant by that!
It's good to get some hands-on info about build techniques. I'm looking to build some in the near future too, so am interested in how the build goes.
This thread goes to show that there are many ways to organise these. It's something that I suspect intimidates a lot of people. |