|
The gain reduction is effecting your program material as determined by the low end voltages.
By rolling off the low end you can effect the area you desire.
When combined with the unaffected signal your low end is as it is.
Likewise, you may not want or need the higher frequencies of your material to be limited with compression so filter them out.
leoaudio
Debatable.
On one side you have those whom feel that careful use of the attack can allow the transients thru and timing the release of the compressor can occur in a similar way to parallel.
On the other, you have those attune to the differences which can be applied to each method.
__________________
------------------------------------------------------
A compressor is a "voltage turn it downer".
You can determine when it begins to turn it down and when it resumes from turning it down, even how quickly it does it's "turn it down" and by how much it turns it down so you can push more voltage into it to be turned down and then make up for gain lossed from turning it down. 
Bart Nettle
|