What's up?! Just grabbed an old non-USB Unitor8 on ebay for $30 in emaculate condition. It works fine as a stand-alone, but I can't get the serial port to see the unit. I got the unidrv227 drivers from another thread on this site and installed them.
Also, my computer didn't have a RS232 port, so I bought a PCI card with 2 of them and installed that as well. In device manager, the card shows up as COM4 and COM5. However, also in the device manager, it's shows the Unitor8 installed, but the location is unknown by the computer? How do I point the port to the Unitor. I am trying to use Control 3 and it doesn't see the unit. I read pages 28-30 in the manual and see where it says to select a serial port. But when I got to into the Unitor settings in the control panel, there is no field for serial port. There are only the inputs and outputs ports.
Also, as a secondary question just in case someone might know, when I was installing the drivers for the RS232 card, there were about 7 folders cantaining drivers on the cd. There was like a 1S, 1P, 2S...4S, 8S... Three of the folders had a couple 32-bit XP drivers. How do I know which folder to select? I selected 8S and one of the 32-bit driver within that. Is that ok?
Here is a screen print of what the Unitor setting menu looks like in the Control Panel. Is there a Port selection setting missing?
