Gearslutz.com - View Single Post

Rokus666 · 6th December 2008

I am a little bit confused.

I took the signal generator from my DAW,1khz sine wave,
Put the signal to -20db, panned it hard left, and the VU input section of the device is reading -7 db VU (all controls normalised)
I can't even trim the meter to come to 0 db VU
The meter can go small increments up and down.
Am I doing something wrong ?

DAW(cubase internal signal generator) 1khz sine -20 db panned left going to input of the compressor with normalised settings. The readout is somewhere around -7 and the meter lets me tweak it maximum +-1 db
So I am not sure if I left out any of the steps...

6th December 2008	#7
Rokus666 Lives for gear Joined: Jul 2008 Location: NYC Posts: 546 Thread Starter 3 Reviews written	I am a little bit confused. I took the signal generator from my DAW,1khz sine wave, Put the signal to -20db, panned it hard left, and the VU input section of the device is reading -7 db VU (all controls normalised) I can't even trim the meter to come to 0 db VU The meter can go small increments up and down. Am I doing something wrong ? DAW(cubase internal signal generator) 1khz sine -20 db panned left going to input of the compressor with normalised settings. The readout is somewhere around -7 and the meter lets me tweak it maximum +-1 db So I am not sure if I left out any of the steps... __________________ ** COMMODORE 64 BASIC V2 ** 64K RAM SYSTEM 38911 BASIC BYTES FREE READY.