Gearslutz.com - View Single Post - Lynx Aurora in a Mixerless Setup?

Pfraser · 6th June 2008

Sorry I'm probably not choosing my words right.

I'm asking if there is a assignable mix/master bus for the analog signal BEFORE it gets converted.

For example.
1.)I have a guitar and piano track in the DAW and I'm tracking vocals.
2.)The guitar and piano are coming out of the daw on channel 15 and 16.
3.)Channels 15 and 16 go into the monitoring system and I use a send to send the guitar and piano to the vocalists headphones.
4.)The Vocalist wants to hear them selves in the headphones
5.) The Vocal chain is mic -> pre -> AD/DA input 1.

Now is it possible to take input 1 and route it to my monitoring outputs before it gets converted and have it simultaneously record? Because if I were to just send them signal from the DAW as they are recording they get the AD/DA delay.

6th June 2008	#5
Pfraser Lives for gear Joined: May 2007 Posts: 558 Thread Starter	Sorry I'm probably not choosing my words right. I'm asking if there is a assignable mix/master bus for the analog signal BEFORE it gets converted. For example. 1.)I have a guitar and piano track in the DAW and I'm tracking vocals. 2.)The guitar and piano are coming out of the daw on channel 15 and 16. 3.)Channels 15 and 16 go into the monitoring system and I use a send to send the guitar and piano to the vocalists headphones. 4.)The Vocalist wants to hear them selves in the headphones 5.) The Vocal chain is mic -> pre -> AD/DA input 1. Now is it possible to take input 1 and route it to my monitoring outputs before it gets converted and have it simultaneously record? Because if I were to just send them signal from the DAW as they are recording they get the AD/DA delay.